Installation

2UR-FSE ENGINE CONTROL SYSTEM: MASS AIR FLOW METER: INSTALLATION

INSTALLATION
HINT: When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

1. INSTALL MASS AIR FLOW METER SUB-ASSEMBLY (for Bank 1)

(a) Install the MAF meter with the 2 screws.
Torque: 0.8 Nm (8 kgf-cm, 7in-lbf)
- If the screw is tightened excessively, the screw hole may be damaged.
- Make sure the O-ring is not pinched.

2. INSTALL MASS AIR FLOW METER SUB-ASSEMBLY (for Bank 2)

(a) Install the air cleaner cap.
for hose clamp - Torque: 3.8 Nm (38 kgf-cm, 34in-lbf)
HINT: Insert the protrusion of the air cleaner hose into the hole of the hose clamp.

4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY RH

(a) Install the air cleaner cap.
for hose clamp - Torque: 3.8 Nm (38 kgf-cm, 34in-lbf)
HINT: Insert the protrusion of the air cleaner hose into the hole of the hose clamp.

5. INSTALL V-BANK COVER SUB-ASSEMBLY Installation