Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2009 >> RX 350 AWD V6-3.5L (2GR-FE) >> Repair and Diagnosis >> Powertrain Management >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation








2GR-FE ENGINE CONTROL SYSTEM: ECM: INSTALLATION

INSTALLATION

1. INSTALL ECM





(a) Install the ECM No. 1 bracket to the ECM with the 2 screws.
(b) Install the ECM No. 2 bracket to the ECM with the 2 screws.
(c) Install the ECM No. 3 bracket to the ECM with the 2 screws.
(d) Install the ECM with the 2 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49in-lbf)
(e) Install the wire harness clamp.
(f) Connect the 5 ECM connectors.
2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
NOTICE:
After replacing the ECM on vehicles with a dynamic laser cruise control system, it is necessary to initialize the ECM so that the ECM can recognize the dynamic laser cruise control system.

(a) Be sure to perform the following procedures after replacing the ECM.
(1) Turn the ignition switch to the ON position.
(2) Turn the cruise main switch on.
(3) With the brake pedal depressed, push the cruise control main switch to RES/ACC 3 times within 3 seconds. Check that the buzzer sounds at this time.
NOTICE:
Do not turn the headlight dimmer switch on at this time because the optical axis automatic adjustment mode has already started, which may lead to an incorrect optical axis setting. If the headlight dimmer switch is turned on by mistake, readjust the optical axis Adjustments.
(4) Turn the ignition switch off.
pro multis · About Operation CHARM