Installation

AIR CONDITIONING: AIR CONDITIONING AND BLOWER UNIT: INSTALLATION

INSTALLATION

1. INSTALL AIR CONDITIONING UNIT ASSEMBLY





(a) Install the A/C unit with the 2 screws, 3 nuts and bolt.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)





(b) Install the wire harness to the A/C unit with the 2 clamps.
2. INSTALL AIRBAG SENSOR ASSEMBLY CENTER





(a) Install the airbag sensor with the 3 bolts.
Torque: 20 Nm (200 kgf-cm, 14 ft-lbf)
3. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
(a) Install the instrument panel safety pad Installation.
4. INSTALL COOLER REFRIGERANT LIQUID PIPE A
(a) Sufficiently apply compressor oil to a new O-ring and the contact surface of the refrigerant liquid pipe.
Compressor oil:
ND-OIL 8 or equivalent
(b) Install the O-ring to the liquid pipe.
(c) Connect the liquid pipe.
5. INSTALL NO. 1 COOLER REFRIGERANT SUCTION PIPE
6. ADD ENGINE COOLANT Service and Repair
7. CHECK REFRIGERANT Service and Repair
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

10. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.
11. WARM UP ENGINE Service and Repair
12. CHECK FOR LEAKAGE OF REFRIGERANT Service and Repair