Installation

2GR-FSE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a coat of engine oil to the O-ring of the sensor.

(b) Install the sensor with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the crankshaft position sensor connector.

2. ADJUST COMPRESSOR OIL Installation

3. INSTALL ELECTRIC INVERTER COMPRESSOR Installation

4. INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE Installation

5. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE Installation

6. INSTALL SERVICE PLUG GRIP Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. CHARGE REFRIGERANT Service and Repair

9. WARM UP ENGINE Service and Repair

10. CHECK FOR LEAKAGE OF REFRIGERANT Service and Repair

11. INSTALL REAR ENGINE UNDER COVER LH

12. INSTALL ENGINE UNDER COVER

13. INSTALL NO. 1 AIR CLEANER INLET Installation

14. INSTALL V-BANK COVER Installation

15. REMOVE COOL AIR INTAKE DUCT SEAL Installation

16. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.