Installation

2GR-FSE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

(a) Install a new gasket to the sensor.

(b) Install the sensor.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(c) Connect the sensor connector.

2. INSTALL INTAKE MANIFOLD Installation

3. INSTALL INTAKE AIR SURGE TANK Installation

4. INSTALL THROTTLE BODY Installation

5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation

6. CONNECT NO. 2 VENTILATION HOSE Installation

7. ADD ENGINE COOLANT Service and Repair

8. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

9. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

10. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

11. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation

12. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation

13. INSTALL FRONT UPPER FENDER PROTECTOR LH Installation

14. INSTALL FRONT UPPER FENDER PROTECTOR RH Installation

15. INSTALL SERVICE PLUG GRIP Installation

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

17. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection

18. CHECK FOR FUEL LEAKS Testing and Inspection

19. CHECK FUNCTION OF THROTTLE BODY On-Vehicle Inspection

20. INSTALL V-BANK COVER Installation

21. INSTALL ENGINE ROOM SIDE COVER LH Installation

22. INSTALL ENGINE ROOM SIDE COVER RH Installation

23. INSTALL COOL AIR INTAKE DUCT SEAL Installation

24. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.