Installation
3UR-FE EMISSION CONTROL: AIR INJECTION DRIVER: INSTALLATION
1. INSTALL AIR INJECTION CONTROL DRIVER ASSEMBLY
(a) Install the air injection control driver with the 3 bolts.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Connect the 4 air injection control driver connectors.
(c) Connect the wire harness clamp.
(d) Connect the ground wire with the bolt.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
3. INSTALL ENGINE ROOM SIDE COVER LH Installation