TRAC OFF Indicator Light does not Come ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: TRAC OFF Indicator Light does not Come ON
- TRAC OFF Indicator Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN communication.

WIRING DIAGRAM

Refer to TRAC OFF Indicator Light Remains ON TRAC OFF Indicator Light Remains ON.

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration Calibration.

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output Diagnosis System.

Result:





B -- INSPECT CAN COMMUNICATION SYSTEM
A -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM (TRAC OFF INDICATOR)

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Select the Active Test on the Techstream Data List / Active Test.

ABS/VSC/TRAC





(d) Check that the multi-information display (TRAC OFF indicator) on the combination meter turns on or off in accordance with the Techstream operation.

OK:

The multi-information display (TRAC OFF indicator) turns on or off in accordance with the Techstream operation.

HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.

NG -- INSPECT COMBINATION METER ASSEMBLY

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY

3. INSPECT COMBINATION METER ASSEMBLY

(a) Turn the engine switch off.

(b) Perform the Active Test of the combination meter (meter CPU) using the Techstream Scan Tool Testing and Procedures.

(c) Check the combination meter.

OK:

The multi-information display turns on or off in accordance with the Techstream operation.

HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step Problem Symptoms Table.

NG -- REPLACE COMBINATION METER ASSEMBLY

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY