Installation

STEERING COLUMN: DRIVING SUPPORT SWITCH CONTROL ECU: INSTALLATION

1. INSTALL DRIVING SUPPORT SWITCH CONTROL ECU

(a) Install the driving support switch control ECU with the bolt.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Connect the connector.

2. INSTALL INSTRUMENT PANEL BOX ASSEMBLY Installation

3. INSTALL INSTRUMENT PANEL BOX DOOR COVER Installation

4. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

6. INSTALL INSTRUMENT SIDE PANEL RH Installation

7. INSTALL NO. 2 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY Installation

8. INSTALL INSTRUMENT LOWER COVER LH Installation

9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

11. INSTALL COWL SIDE TRIM BOARD RH Installation

12. INSTALL DOOR SCUFF PLATE ASSEMBLY RH Installation

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

14. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Description and Operation.