Installation
2AZ-FXE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
1. INSTALL OXYGEN SENSOR
(a) Temporarily tighten the oxygen sensor.
NOTICE:
Do not damage the oxygen sensor.
(b) Using SST, fully tighten the oxygen sensor.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)
NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.23 in.).
* This torque value is effective when SST is parallel to the torque wrench Service Precautions.
(c) Connect the oxygen sensor connector.
2. INSPECT FOR EXHAUST GAS LEAK