Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2011 >> IS 250 AWD V6-2.5L (4GR-FSE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Front Airbag Sensor >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation





SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.

1. INSTALL FRONT AIRBAG SENSOR

(a) Check that the engine switch is off.

(b) Check that the battery negative (-) terminal is disconnected.

CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Connect the connector.





(d) Install the front airbag sensor with the 2 bolts.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(e) Check that there is no looseness in the installation parts of the front airbag sensor.

2. INSTALL HEADLIGHT ASSEMBLY Installation

3. INSTALL FRONT UPPER FENDER PROTECTOR Installation

4. INSTALL ENGINE ROOM SIDE COVER LH (for LH Side)

for 2GR-FSE: Installation

for 4GR-FSE: Installation

5. INSTALL ENGINE ROOM SIDE COVER RH (for RH Side)

for 2GR-FSE: Installation

for 4GR-FSE: Installation

6. INSTALL FRONT BUMPER ASSEMBLY Installation

7. INSTALL RADIATOR GRILLE PROTECTOR Installation

8. INSTALL COOL AIR INTAKE DUCT SEAL Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.

11. INSPECT AND ADJUST HEADLIGHT AIMING

Adjustments

12. INSPECT AND ADJUST FOG LIGHT AIMING

Adjustments
pro multis · About Operation CHARM