Installation

BRAKE CONTROL: STEERING ANGLE SENSOR: INSTALLATION

NOTICE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

1. INSTALL STEERING ANGLE SENSOR

2. INSTALL SPIRAL CABLE SUB-ASSEMBLY Installation

3. INSTALL STEERING COLUMN COVER (w/o Driver Monitor Camera) Installation

4. INSTALL STEERING COLUMN COVER (w/ Driver Monitor Camera) Installation

5. ADJUST SPIRAL CABLE SUB-ASSEMBLY Installation

6. INSTALL STEERING WHEEL ASSEMBLY Installation

7. INSTALL STEERING PAD Installation

8. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

9. INSTALL SWITCH AND VOLUME CASE

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation

11. INSTALL COWL TOP VENTILATOR LOUVER RH Installation

12. INSPECT STEERING PAD Installation

13. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.

14. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.