Installation

1UR-FSE STARTING: STARTER (for AWD): INSTALLATION

1. INSTALL STARTER ASSEMBLY





Install the flywheel housing side cover.





Connect the starter connector.

(a) Connect the starter wire with the 2 nuts.

for nut A - Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

for nut B - Torque : 9.8 Nm (100 kgf-cm, 88 in-lbf)

(b) Close the terminal cap.





Install the starter with the 2 bolts.

Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)





NOTICE:
Make sure the flywheel housing cover is as shown in the illustration.

2. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR





Install the heat insulator with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

3. INSTALL FRONT NO. 2 ENGINE MOUNTING BRACKET RH Installation

4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Install the exhaust manifold RH Installation.