Installation

CRUISE CONTROL: MILLIMETER WAVE RADAR SENSOR: INSTALLATION

1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Tighten the 3 bolts on the millimeter wave radar sensor assembly.





Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

HINT
Tighten the bolts in the order indicated in the illustration.

(b) Connect the connector.

2. INSTALL FRONT BUMPER ASSEMBLY Installation

3. INSTALL HOOD CENTER CUSHION Installation

4. ADD WASHER FLUID (w/ Headlight Cleaner System)

5. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT Adjustments

6. PREPARE FOR FOG LIGHT AIMING Adjustments

7. INSPECT FOG LIGHT AIMING Adjustments

8. ADJUST FOG LIGHT AIMING Adjustments

9. ADJUST MILLIMETER WAVE RADAR SENSOR Adjustments

10. INSTALL COOL AIR INTAKE DUCT SEAL Installation

11. INSTALL ENGINE ROOM SIDE COVER Installation

12. INSTALL ENGINE ROOM SIDE COVER LH Installation