Installation

NAVIGATION: NAVIGATION ECU: INSTALLATION

1. INSTALL NAVIGATION ECU

(a) Install the navigation ECU with the 4 screws.





(b) Connect each connector to install the harness.

(c) Engage the clamp.

2. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY ASSEMBLY Installation

3. INSTALL NO. 2 RADIO BRACKET Installation

4. INSTALL NO. 1 RADIO BRACKET Installation

5. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY Installation

6. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Installation

7. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

8. INSTALL FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Installation

9. INSTALL INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray) Installation

10. INSTALL FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Installation

11. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Installation

12. INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Installation

13. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) Installation

14. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) Installation

15. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

16. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)

17. INSERT MAP DISC

(a) Remove the clock assembly





(b) Turn the engine switch on (ACC).

(c) Insert the map disc.

(d) Check that the wire harness is in the position shown in the illustration.





Text in Illustration





(e) Engage the 2 craws and install the clock assembly.





18. ADJUST CLOCK