Installation

P313 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: INSTALLATION

1. INSTALL SHIFT LEVER POSITION SENSOR

(a) Install the shift lever position sensor to the manual valve shaft.

(b) Temporarily install the 2 bolts.

Text in Illustration

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Temporarily install the control shaft lever.

(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.

(f) Remove the control shaft lever.

(g) Align the protruding part with the neutral basic line.

Text in Illustration

NOTICE:
There is play on the nut stopper side (protruding part). Align the center point of the range of the play with the neutral basic line.

(h) Tighten the 2 bolts in the order shown in the illustration.

Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

(i) Using a screwdriver, stake the nut with the lock plate.

Text in Illustration

(j) Install the control shaft lever, washer and nut.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(k) Connect the shift lever position sensor connector.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY Installation

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSTALL REAR DECK FLOOR BOX Installation

5. INSPECT SHIFT LEVER POSITION SENSOR POSITION Adjustments

6. ADJUST SHIFT LEVER POSITION SENSOR POSITION Adjustments

7. INSPECT SHIFT LEVER POSITION Adjustments

8. ADJUST SHIFT LEVER POSITION Adjustments

9. INSPECT SHIFT LEVER OPERATION Adjustments

10. INSTALL NO. 1 ENGINE UNDER COVER