Canada - Instruments - Compass Calibration Procedure

L-TCI-3203

September 14, 2012

INITIAL CALIBRATION OF COMPASS DURING PDS

Service Category
General

Section
Pre-Delivery Service

Market
Canada





APPLICABILITY:





INTRODUCTION:

2013 model year IS 250/350 vehicles are equipped with a compass in the rear view mirror. Use the following procedure to complete initial calibration of the compass during Pre-Delivery Service (PDS).





WARRANTY INFORMATION:

COMPASS CALIBRATION PROCEDURE:

1. Cycle the ignition switch to the "IG-ON" position and check that the direction (N, NE, E, SE, S, SW, W, NW) appears on the compass display.





2. Push and hold the "AUTO" switch for approximately 6 seconds until the zone number (1 - 15) appears on the display. Then push the switch to select the number of the zone where the vehicle is located.





See the map in figure 3 for zone reference.





3. Start the engine and push and hold the "AUTO" switch for about 12 seconds until "CAL" appears on the display.





4. Drive the vehicle slowly at 8km/h (5 mph) or less, in a circle until the direction is displayed. If there is NOT enough space to drive in a circle, drive around the block until the direction is displayed.

When the direction is shown on the display, the calibration is complete.

© 2012 Lexus, a division of Toyota Motor Sales, Canada