Compressor

1. Disconnect battery negative cable.
2. Discharge refrigerant from system.
3. Disconnect compressor clutch wires from field coil connector on compressor.
4. Disconnect discharge and suction hoses from compressor manifolds. Cap refrigerant lines and compressor manifolds to prevent contamination.
5. Remove compressor drive belt.
6. Remove three bolts securing front of compressor to power steering pump support and compressor brace.
7. Remove two bolts securing rear compressor brace to power steering pump support.

Fig. 38 Motorcraft FS-6 six cylinder compressor removal:

8. Remove compressor and rear brace, Fig. 54, as an assembly from vehicle.
9. Reverse procedure to install.