System Reactivation Procedures

To Reactivate System:
1. Disconnect battery ground cable and backup power supply.
2. Remove jumper wire from air bag terminals on clockspring assembly and passenger air bag harness connector if connected.
3. Reconnect driver air bag connector.
4. Position driver air bag on steering wheel and secure with four nut and washer assemblies (10 mm). Tighten nut and washer assemblies to 4-6 N.m (35-53 lb-in).
5. Reconnect passenger air bag connector.
6. Close glove compartment door.
7. Connect backup power supply and battery ground cable.
8. Verify air bag indicator.