Programming - Transmitter

To program (or re-program) transmitter(s) into the remote/keyless entry module, perform the following steps:

1. Turn ignition switch to ON or ON/ACCESSORY position and momentarily short the two terminals of the Program Connector (J4) (a two-pin connector taped to the wire assembly and accessed by dropping the glove compartment). All doors should lock then unlock.
2. Press any button on transmitter. All doors should lock the unlock.
3. Repeat Step 2 to program additional transmitters into the control module (up to four transmitter maximum).
4. Turn ignition OFF. All doors should lock then unlock.
5. Check operation.

NOTE: If door locks do not respond, press button again (up to three times maximum with the same transmitter). If door locks still fail to respond, go to Pinpoint Test I.