Condenser HVAC: Service and Repair

Removal

NOTE: Whenever the condenser is replaced, it is necessary that the suction accumulator/drier also be replaced.

NOTE: If a condenser leak is suspected, the condenser must be leak-tested before it is removed from the vehicle.

1. Discharge refrigerant from A/C system at service access gauge port valve location on suction line. Observe all safety precautions.

2. Disconnect two refrigerant lines at fittings on RH side of radiator following procedure for disconnecting spring lock couplings.










3. Remove four bolts retaining condenser to radiator support and remove condenser from vehicle.


Installation

1. Position condenser assembly to radiator support brackets. Install retaining bolts.

2. Connect refrigerant lines to condenser assembly using procedures for connecting spring lock couplings as outlined.

3. Leak-test, evacuate and charge refrigerant system following recommended service procedures. Observe all safety precautions.