Rear Doors

Removal

Front And Rear Door Switch Assemblies:

1. Carefully pry front of switch housing up from armrest using a flat-blade tool and unhook rear of housing.
2. Remove wiring connector by carefully prying connector from switch base with a small thin-bladed screwdriver.
3. Remove two switch retaining screws and remove switch from the housing.

Installation

1. Install switch to switch housing using two retaining screws.
2. Install wiring connector to switch base by pressing firmly into place.

NOTE: The connector is "keyed" and can only be installed one way.

3. Install switch housing to door armrest by hooking spring clip into armrest, rotating switch housing down and firmly pressing housing retaining legs into armrest pushnuts.