Air Bag Control Module: Service and Repair

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE POSITIVE BATTERY CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect positive battery cable.
2. Lower glove compartment down past stops (press in sides).
3. Remove heater duct above glove compartment.
4. Depress monitor retaining tabs and lower monitor from bracket (blue box, two connectors).







5. Disconnect two monitor connectors.

Installation
1. Connect two monitor electrical connectors.
2. Position monitor to bracket and secure with retaining tabs.
3. Install heater duct.
4. Return glove compartment to proper position.
5. Connect positive battery cable.
6. Verify air bag warning indicator.