Windows and Glass: Service Precautions

On models with passenger side airbag, both airbags modules must be disconnected to properly disarm system.

DEACTIVATE
1. Disconnect negative, then positive battery cable. Wait one minute for backup power supply to deplete.
2. Remove four nut and washer assemblies retaining driver airbag module to the steering wheel.
3. Disconnect driver airbag module connector.
4. Open glove compartment and rotate completely past stops. Disconnect passenger side airbag connector.
5. Attach Rotunda Airbag Simulator 105-00010 or equivalent, to airbag terminals on clockspring assembly to simulate airbag.
6. Attach a second Rotunda Airbag Simulator 105-00010 or equivalent, to airbag terminals on wiring harness side of passenger airbag module connector.
7. Connect battery cables.

REACTIVATE
1. Disconnect negative, then positive battery cable. Wait one minute for backup power supply to deplete.
2. Wait one minute for backup power supply to discharge.
3. Remove airbag simulator from vehicle harness connector at top of steering column.
4. Connect driver airbag connector.
5. Position airbag assembly on steering wheel and secure with four nut and washer assemblies.
6. Remove airbag simulator from vehicle harness connector at passenger airbag.
7. Connect passenger airbag connector.
8. Connect battery cables. Place ignition switch in RUN position, and note air bag warning lamp operation. Lamp should illuminate for approximately 6 seconds, then turn OFF.