System Reactivation Procedures

WARNING: The air bag simulator must be removed and the air bag reconnected when the system is reactivated to avoid non-deployment in a collision resulting in possible personal injury.

1. Disconnect battery ground cable.
2. Wait one minute for backup power supply in air bag diagnostic monitor to deplete stored energy.
3. Remove Rotunda Air Bag Simulator 105-00011 or equivalent from vehicle harness connector at top of steering column.
4. Install driver side air bag module.
5. Remove Rotunda Air Bag Simulator 105-00010 or equivalent from vehicle harness connector on passenger side. Reconnect and install passenger side air bag module.
6. Reconnect battery ground cable.
7. Prove out system.
8. Reprogram radio frequencies and set clock.