Brake Switch (Cruise Control): Service and Repair

REMOVAL

NOTE: Switch is assembled locked with a 45 degree clockwise turn and lock plug must be turned 65 degree counterclockwise to allow connector insertion and plunger adjustment.

1. Disconnect the battery ground cable.







2. Remove the deactivator switch.
1 Disconnect the electrical connector.
2 Rotate counterclockwise 45 degree and remove the deactivator switch.

INSTALLATION







1. Release the plunger lock, and turn the lock knob counterclockwise until the first click is felt.
2. Fully depress the brake pedal.







3. Install the deactivator switch.
1 Position the deactivator switch in the bracket and rotate clockwise 45 degree.
2 Connect the electrical connector.
4. Slowly release the brake pedal and give it a slight tug once it reaches the rest position. (An extra click may be heard when tugging on the pedal.)
5. Connect the battery ground cable.