Programming and Relearning

NOTE: When installing a new RCM it must be programmed for the applicable vehicle configuration. Program the RCM using the following procedure.

1. Make sure that all of the SRS components are installed and that the battery is connected.
2. Connect a scan tool to the Data Link Connector (DLC).
3. Key to RUN.
4. Follow scan tool manufacturer's instructions to configure the RCM for the side air bag option required.
Select:
^ "Air Bag Configuration 12" for Continental with side air bags.
^ "Air Bag Configuration 13" for Continental without side air bags.
5. Key to OFF.
6. Prove out the system.

WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE SAFETY STANDARDS.

NOTE: If the prove out reveals Lamp Fault Codes (LFCs), refer to the Diagnostic Trouble Code (DTC) Priority Table. Diagnostic Trouble Code Tests and Associated Procedures