Caliper Removal and Installation

Removal

WARNING: Use of any other than approved DOT 4 or DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.

CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.





3. Remove the caliper flow bolt.
- Discard the copper washers.





4. Remove the caliper.
1 Remove the caliper bolts.
2 Lift the caliper off the caliper anchor plate.





5. Inspect the caliper.
- If leaks or damaged boots are found, disassembly is required.

Installation








1. To install, reverse the removal procedure.
- Install new copper washers.
- Bleed the caliper.