Caliper Disassembly and Assembly
Disassembly
WARNING: Use of any other than approved DOT 4 or DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
1. Remove the brake caliper.
2. Drain the brake fluid from the brake caliper.
3. Secure the brake caliper in a vise.
4. Turn the brake piston counterclockwise with Rear Caliper Piston Adjuster.
5. Remove the brake piston from the caliper bore.
6. Remove and discard the piston dust boot and piston seal from the caliper bore.
Assembly
1. CAUTION: Do not reuse piston seals or dust boots. Install new seals and dust boots or damage to the vehicle can occur.
Note: Use new brake fluid when assembling and bleeding the brake system.
To install, reverse the disassembly procedure.