Daytime Running Lamp: Testing and Inspection

NOTE: The FEM must be reconfigured upon replacement. Refer to Module Communications Network (Information Bus).

1. Verify the customer concern by operating the DRL following these steps:
1 Place the ignition switch in the RUN position.
2 Place the autolamp switch in the OFF position.
3 Place the headlamp switch in the OFF or PARK position.

2. Verify the parking lamp operation.
1 Place the headlamp switch in the PARK position.

If at least one of the parking lamps operates correctly, proceed to the next step. If none of the parking lamps operate, refer to Parking Lamps.

3. Verify the high beam headlamp operation.
1 Place the headlamp switch in the ON position.
2 Place the multifunction switch in the high beam headlamp position.

If the high beam headlamp operation is correct and the DRL operation is incorrect, install a new FEM; refer to Multifunction Electronic Control Module.

If the high beam operation is incorrect, refer to Headlamp.