Compressor Cut-Off/Cycling Switch

REMOVAL
1. Disconnect the battery ground cable. For additional information, refer to Battery.







2. Remove the junction block splash shield.







3. Disconnect the cable ends.







4. Remove the junction block bracket.
1 Disengage the connector.
2 Remove the screws.
3 Remove the junction block bracket.







5. Disconnect the A/C cycling pressure switch electrical connector.







6. Remove the A/C cycling switch from the top of the suction accumulator.

INSTALLATION












1. To install, reverse the removal procedure.
^ Lubricate the O-ring seal with PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN-12-C), or equivalent, meeting Ford specification WSH-M1C231-B.
2. Carry out the refrigerant system Leak Detection.