Windshield Washer Switch: Service and Repair

Removal
1. Disconnect the battery ground cable.





2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and tom to the RUN position.
2. Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.





3. Remove the tilt wheel handle and shank.





4. Remove the upper and lower steering column shrouds.
1. Remove the screws.
2. Remove the shrouds.





5. Remove the multifunction switch.
1. Remove the screws.
2. Disconnect the electrical connectors.
3 Remove the switch.

Installation





1. Note: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn its strategy.

To install, reverse the removal procedure.