Crankshaft Main Bearing
| Main Bearing Journal Diameter | 67.483-67.503 mm | |
| Main Bearing Bore Diameter | 72.40-72.424 mm | |
| Main Bearing Journal Diameter | Maximum Out-of-Round | 0.075 mm between cross sections |
| Main Bearing Journal Diameter | Maximum Taper (Straightness) | 0.004 mm |
| Runout | FIM of Center Journals When Located on Front and Rear Journal | 0.05 mm (3 places) |
| Crankshaft Journal to Main Bearing Clearance | 0.066-0.024 mm | |
| Jack Screws The jack screws are a part of the main bearing cap assembly, and are screwed into the main caps, not the cylinder block. | Stage 1 | 5 Nm (44.6 in.lb) |
| Stage 2 | 9-11 Nm (80-97 in.lb) | |
| Main Bearing Cap Cross Bolts | Stage 1 | 10 Nm (89.2 in.lb) |
| Stage 2 | 19-23 Nm (14-17 ft.lb) | |
| Main Bearing Cap Bolts | Stage 1 | 40 Nm (30 ft.lb) |
| Stage 2 | Additional 90 degrees |