Keyless Entry Remote Transmitter Programming

NOTE: The Driver Door Module (DDM) will erase all previously stored keyless entry remote transmitters when a new transmitter is programmed. If adding an additional transmitter, the existing transmitters stored in memory must be programmed at the same time.

1. Cycle the ignition switch eight times from OFF to ON with in 10 seconds.

NOTE: On the eighth cycle the key must end in the ON position.

2. After the doors lock then unlock press any button on the transmitter to be programmed.
3. The doors will lock and unlock to confirm programming.
4. If additional transmitters are to be programmed, program each transmitter within 7.5 seconds of the last transmitter.
5. After the last transmitter is programmed, turn the ignition switch to OFF. The door locks will lock then unlock and the horn will sound to confirm programming.
6. After all transmitters are programmed:
^ A new keyless entry keypad code can be programmed within 7.5 seconds of the last transmitter.
^ Press keyless entry keypad buttons 7/8 and 9/0 at the same time to exit the program mode.
^ Wait for 7.5 seconds; the DDM will exit the program mode automatically.