Power Steering System Filling

Power Steering System Filling

1. WARNING: Do not mix fluid types. Any mixture of an unapproved fluid could lead to seal deterioration and leaks. A leak could ultimately cause loss of fluid, which could result in a loss of power steering assist.

Fill the power steering reservoir to the appropriate level.
^ Use Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX or equivalent meeting Ford specification MERCON.
2. Remove the Coil On Plug (COP) Fuse 12 in the underhood Auxiliary Junction Box (AJB) to disable the engine from starting.
3. Raise the front wheels off the floor.

4. CAUTION: Do not operate the starter motor for more than 10 seconds at a time. Damage to the starter motor could result.

Turn the steering wheel from stop to stop while cranking the engine.
5. Lower the vehicle.

6. CAUTION: Do not overfill the power steering fluid reservoir.

Fill the power steering fluid reservoir to the appropriate level.
^ Use Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX or equivalent meeting Ford specification MERCON.
7. Install the COP fuse.

8. NOTE: If the power steering is noisy and accompanied by evidence of aerated fluid, it will be necessary to purge the power steering system.

Clear the Diagnostic Trouble Codes (DTCs).
^ Run the vehicle and check the system for leaks.

1Can be purchased as a separate item.