Battery Cable: Service and Repair

BATTERY CABLES

Part 1:

Part 2:

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery.
3. Remove the nut and position the ground cable terminal aside at the starter.
- To install, tighten to 22 Nm (16 lb-ft).

4. Remove the nut and position the starter solenoid positive cable terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

5. Remove the nut and position the starter solenoid wire terminal aside.
- To install, tighten to 5 Nm (44 lb-in).

6. Disconnect the 2 battery cable harness locators from the A/C compressor mounting bolts.
7. Remove the bolt and position the battery ground cable-to-frame terminal aside.
- To install, tighten to 30 Nm (22 lb-ft).

8. Remove the nut and position the generator harness terminal and the CJB cable terminal aside.
- To install, tighten to 9 Nm (80 lb-in).

9. Remove the bolt and position the battery ground cable-to-cowl panel terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

10. Disconnect the battery cable harness in-line electrical connector and remove the battery cable assembly.
11. To install, reverse the removal procedure.