Ignition Switch: Service and Repair

Ignition Switch

Ignition Switch:

Removal and Installation
1. Remove the steering wheel.

2. NOTE: Lower tilt release handle to access second screw.

Remove the lower steering column shroud.
^ Remove the screws.

3. NOTE: The screw is located behind the multi-function switch.

Remove the screw and the upper steering column shroud.





4. Remove the bolt, push the release and position the multi-function switch aside.





5. Disconnect the ignition switch electrical connector.





6. Remove the ignition switch.
7. To install, reverse the removal procedure.
^ Make sure that the spring located under the ignition switch is positioned on the steering column lock rod.