Front

HEATED SEAT MODULE - FRONT

Special Tool(s):

Special Tool(s)

Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Position the front passenger seat to access the heated seat module.
2. Depower the SRS.
3. From under the front of the front passenger seat, remove the heated seat module.
- Vehicles with power seat track, remove the 2 screws and lower the bracket (if equipped).
- Disconnect the heated seat module electrical connector.
- Remove the screw and heated seat module.

4. To install, reverse the removal procedure.
5. Repower the SRS. Do not prove out the SRS at this time.
6. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.