Window Regulator Motor - Rear

WINDOW REGULATOR MOTOR - REAR

Removal







1. Remove the rear corner trim. For SuperCab vehicles, remove the B-pillar trim panel. For SuperCrew vehicles, remove the C-pillar trim panel.
2. Remove the rear trim panel pin-type retainers.
3. Remove the rear trim panel.
4. Disconnect the rear window glass motor electrical connector.







5. Remove the 3 rear window glass regulator and motor assembly screws.







6. Carefully remove the 3 bolts attaching the steel bracket to the plastic cable housing.







7. Hold the plastic cable housing and motor together, place a screwdriver between the drum (located in the cable housing) and the motor housing and pry the motor away from the drum, making sure the drum stays inside the plastic cable housing.

Installation






1. Align the motor gear splines onto the drum and press the motor into place, making sure there is correct alignment of the attachment bolt holes.
- Install the 3 bolts attaching the steel bracket to the plastic cable housing.







2. Install the rear window glass regulator and motor assembly screws.
- Tighten to 11 Nm (8 lb-ft).
3. Connect the rear window glass motor electrical connector.
4. Install the rear trim panel







5. Install the rear trim panel pin-type retainers.
6. Install the rear corner trim. For SuperCab vehicles, install the B-pillar trim panel. For SuperCrew vehicles, install the C-pillar trim panel.