Battery Cable: Service and Repair

BATTERY CABLES

Part 1:

Part 2:

Removal and Installation
1. Remove the battery tray
2. Remove the bolt and position the battery cable body ground terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

3. Remove the starter solenoid terminal cover.
4. Remove the nut and position the battery cable starter solenoid terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

5. Remove the nut and position the starter motor solenoid wire terminal aside.
- To install, tighten to 5 Nm (44 lb-in).

6. Release the battery cable locator from the engine.
7. Remove the bolt and position the battery cable transaxle ground terminal aside.
- To install, tighten to 10 Nm (89 lb-in).

8. Release the battery cable locator from the transaxle stud bolt.
9. Release the 3 battery cable locators from the LH valve cover.
10. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).

11. Remove the battery cables.
12. To install, reverse the removal procedure.