Pinpoint Test AR: DTC U3003:17 (Accessory Protocol Interface Module (APIM))

Information and Entertainment System

Pinpoint Tests

Pinpoint Test AR: DTC U3003:17 (Accessory Protocol Interface Module (APIM))

Normal Operation
- DTC U3003:17 (Battery Voltage: Circuit Voltage Above Threshold) - set by the Accessory Protocol Interface Module (APIM) when the supply voltage is greater than 15.8 volts for more than 250 milliseconds during normal operation.

This pinpoint test is intended to diagnose the following:

- Charging system concern
- APIM



PINPOINT TEST AR: DTC U3003:17 (APIM)

NOTE: DTC U3003:17 may be stored in the module memory due to past battery charging or vehicle jump starting events.

-------------------------------------------------
AR1 CHECK FOR HIGH VOLTAGE DTCs SET IN OTHER MODULES


- Ignition ON.
- Retrieve the continuous DTCs from all modules.
- Is DTC B1317, B1676, B0563 (PCM), or U3003:17 set in more than one module?

Yes
REFER to Charging System to diagnose an overcharging condition.

No
GO to AR2.

-------------------------------------------------
AR2 CHECK THE BATTERY VOLTAGE


- Turn off all interior/exterior lights and accessories.
- Start and run the engine at approximately 2,000 rpm for 3 minutes while monitoring the battery voltage.
- Does the battery voltage rise to 15.5 volts or higher?

Yes
REFER to Charging System to diagnose an overcharging condition.

No
GO to AR3.

-------------------------------------------------
AR3 RECHECK FOR DTC B1317


- Ignition OFF.
- Ignition ON.
- Clear the APIM DTCs.
- Repeat the APIM self-test.
- Is DTC U3003:17 present?

Yes
INSTALL a new APIM. REFER to Accessory Protocol Interface Module (APIM) Accessory Protocol Interface Module (APIM). TEST this system for normal operation.

No
The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.

-------------------------------------------------