Selector Lever

Selector Lever









Removal

1. Remove the selector lever bezel. For additional information, refer to Selector Lever Bezel Selector Lever Bezel.

2. Disconnect the selector lever electrical connector.





3. Disconnect the selector lever cable end from the selector lever ballstud.





4. Depress the 2 tabs and remove the selector lever cable from the selector lever.





5. Remove the 4 selector lever bolts and the selector lever from the vehicle.





Installation

1. Install the selector lever and the 4 selector lever bolts.
- Tighten to 10 Nm (89 lb-in).





2. Install the selector lever cable in the selector lever.
- Be sure the tabs are locked in place.





3. Connect the selector lever cable end to the selector lever ballstud.





4. Connect the electrical connector.





5. Install the selector lever bezel. For additional information, refer to Selector Lever Bezel Selector Lever Bezel.

6. Check the selector lever cable adjustment. Make sure that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE. If an adjustment is necessary, refer to Selector Lever Cable Adjustment Adjustments.