Power Transfer Unit (PTU) - Installation

Power Transfer Unit (PTU) - 3.7L

Power Transfer Unit (PTU)










1. NOTE: A new compression seal must be installed whenever the Power Transfer Unit (PTU) is removed from the vehicle.
Using a suitable tool, install the new compression seal.






2. Position the PTU (Power Transfer Unit) in place and install the 5 PTU (Power Transfer Unit) bolts.
- Tighten to 90 Nm (66 lb-ft).


3. Position the PTU (Power Transfer Unit) support bracket in place and install the 3 PTU (Power Transfer Unit) support bracket-to-engine bolts.
- Tighten to 70 Nm (52 lb-ft).






4. Install the 2 PTU (Power Transfer Unit) support bracket-to-PTU (Power Transfer Unit) bolts.
- Tighten to 70 Nm (52 lb-ft).






5. Position the engine roll restrictor to the transaxle and install the 2 bolts.
- Tighten the engine roll restrictor-to-transaxle bolts to 103 Nm (76 lb-ft).

- Tighten the rear engine roll restrictor bolt to 90 Nm (66 lb-ft).


6. NOTE: Line up the index marks made during removal.
Install the 4 driveshaft-to-output flange bolts.

- Tighten to 70 Nm (52 lb-ft).


7. Install the RH catalytic converter.

8. Install the RH front halfshaft.

9. Top off fluids as necessary.