Power Locks - Drivers Lock Won't Lock/Unlock Other Doors

9215mazda01

Bulletin No.: 018/91
Issued: 11/22/91
Revised:


Subject: POWER DOOR LOCKS MALFUNCTION


Applicable Model/s: 1988-'91 626/MX-6


Category: S


DESCRIPTION

A driver's side door lock that does not lock or unlock the remaining doors may have a damaged circuit in the door lock switch.

Modified switches have been installed in production vehicles starting June 3, 1991 (Hofu production) and June 25, 1991 (Flat Rock production). These modified switches are not interchangeable with switches on vehicles produced prior to June 3rd and June 25th respectively.

Vehicles produced prior to June 3rd and June 25th that experience this driver door lock problem, should have switches replaced with the original switch. The replacement switch must be water-proofed to prevent problem reoccurrence. See Repair Procedure for instructions.


VIN OF PRODUCTION CHANGE

Japan Made - 626/MX-6 JM1GD****M1917355 June 3, 1991
USA Made - 626 1YVGD22B8M5186161 June 25, 1991


REPAIR PROCEDURE

1. Inspect switch. See Section 14 or S of the Workshop Manual.





2. If necessary, replace the driver's door lock switch. See Workshop Manual for replacement procedures. Figure 1.

NOTE:
The modified parts are not interchangeable with the original parts. Refer to the VIN and Parts Information for correct model-to-parts application.





3. Using Three-Bond Synthetic Rubber-Type Adhesive (1521) or equivalent (silicon sealer), apply adhesive around the attaching nuts. Figure 2.

4. Allow adhesive to dry for about 10 minutes. Install the door lock mechanism and the door panel.





PARTS INFORMATION


WARRANTY INFORMATION

Warranty Type Code: A
Customer Comment Code: 41 or 42
Damage Code: 93
Quantity: 1
Part No. of Main Cause: G212 58 312A or GJ24 58 312A
Operation No: S1007XRX
Labor Hours: 0.4 Hr.