Hold Switch

HOLD SWITCH

Inspection of Operation





1. Turn the ignition switch ON.
2. Verify that the HOLD indicator illuminates while the switch is depressed. Release the switch and make sure the HOLD indicator is out.
3. If it is not working properly, check the terminal voltage of the hold switch.

Inspection of Terminal Voltage





1. Remove the console box.
2. Turn the ignition switch ON.
3. Measure the voltage between terminal and a ground while depressing the switch.





4. If not correct, check continuity between the terminals.

Inspection of Continuity

1. Disconnect the hold switch connector.





2. Check continuity between the terminals while depressing the switch.





3. If not correct, replace the hold switch.