Shift Interlock: Adjustments

Adjustment





1. Remove the front and rear console.
2. Remove the indicator screws and lift up the indicator panel.
3. Shift the selector lever to P range.
4. Loosen the locknut as shown.





5. Adjust the lever so that the clearance between the guide plate and the guide pin in P range with the push rod lightly depressed is as shown.
6. Tighten the locknut.

Tightening torque: 20 - 28 N.m {2.0 - 2.9 kgf.m, 15 - 20 ft lbf}

7. Move the selector lever to N and D ranges and verify that the clearance between the guide plate and the guide pin is the same at both positions.
8. If not as specified, readjust the lever.
9. Install and adjust the indicator panel.
10. Install the front and rear console.
11. Connect the negative battery cable.