Brake Vacuum Line - Rattle Noise

Bulletin No.: 011/97
Issued: 05/19/97
Revised:

Category
S

Applicable Model/s
1993-95 RX-7

Subject:
RATTLING NOISE FROM DASHBOARD AT IDLE WITH BRAKES APPLIED

DESCRIPTION
A rattling noise may be heard from the dashboard when pressing the brake pedal at idle. This noise is transmitted through the body by the check valve operating in the brake vacuum line. Customers complaining of this noise should have the vehicle inspected and if necessary, repaired according to this bulletin.

NOTE:
This noise may occur after performing "Brake Vacuum Hose" recall campaign # 65609.

REPAIR PROCEDURE

1. Verify the concern.





2. Loosen the two (2) bolts attaching the vacuum pipe to the cowl panel.
^ Remove and discard brake booster side bolt only.

3. Install a rubber mount into the attaching bolt hole.

4. Tighten rubber mount into the firewall.
Tightening Torque: 0.7 - 1.1 kgf-m (5-8 ft-lbs)

5. Install vacuum pipe to the rubber mount, retighten bolt loosened in step 2.
Tightening Torque: 0.7 - 1.1 kgf-m (5-8 ft-lbs)





PARTS INFORMATION





WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term Information).





Disclaimer