Transmission Position Sensor/Switch: Adjustments

1. Disconnect the negative battery cable.
2. Remove the resonance duct and the air cleaner housing assembly.
3. Remove the spring pin and clip; and disconnect the selector cable.
4. Rotate the manual shaft to the N position.
5. Disconnect the transaxle range switch connector.
6. Loosen the transaxle range switch mounting bolts.

View: Checking Continuity Between Terminals A & H:

7. Connect an ohmmeter between terminals A and H.
8. Adjust the switch to the point where there is continuity between the terminals.
9. Tighten the transaxle range switch mounting bolts.

Tightening torque: 7.9 - 10.7 Nm (70 - 95 in.lb.)

10. Verify that the selector lever range position and transaxle range switch are aligned.
11. Connect the transaxle range switch connector.
12. Connect the selector cable and install spring pin and clip.
13. Install the air cleaner housing assembly and the resonance duct.