Distributor: Service and Repair

Distributor Removal / Installation:

COMPONENTS
2. Spark plug wires.
3. Connector.
4. Distributor with coil and ignition control module.

REMOVAL
1. Remove spark plug wires.
2. Disconnect wiring harness.
3. Turn crankshaft to #1 cylinder TDC.
4. Remove mounting bolt and lift off distributor. Do not turn engine while distributor is removed.

INSTALLATION
Install in reverse order of removal and note the following:

1. Coat O-ring with engine oil.
2. Ensure that #1 cylinder is at TDC.
3. Align distributor drive blade with slot in camshaft.
4. After installation, adjust ignition timing.
5. Tighten mounting bolt:

Tightening Torque: 19 - 25 Nm (14 - 18 ft.lb.)