With SST-New Generation Star Tester (Data Monitor)

With SST-New Generation Star Tester
1. In the passenger compartment, connect the SST to the data link connector-2 as shown in the figure.
2. Referring to the NGS operational manual, select the RID DATA MONITOR AND RECORD or RID DATA MONITOR function.
3. Referring to the following list, inspect each ECM input/output signal.

Note:
- The RID DATA MONITOR AND RECORD or RID DATA MONITOR function is to monitor the calculation value of input/output signals in the ECM. Deviation in the value does not always indicate malfunction in the related input/output devices (sensors and solenoids).
- For inspection of the input/output signals other than listed below, check voltage at the applicable ECM terminal by using the SST (Monitor, Engine Signal).

4. If normal output signal cannot be detected when all input signals are normal, replace the ECM.

Link Monitor Table
PID DATA MONITOR AND RECORD (DIAGNOSTIC DATA LINK)

Part 1 Of 2:

Part 2 Of 2:

PID DATA MONITOR (GENERIC OBDII FUNCTIONS)