Transmission Position Sensor/Switch: Adjustments

1. Disconnect the negative battery cable.
2. Remove the battery, air cleaner assembly, and battery carrier.
3. Remove the nut and clip; and disconnect the selector cable.
4. Rotate the manual shaft to the N position.
5. Disconnect the transaxle range switch connection
6. Loosely tighten the transaxle range switch mounting bolts.




7. Connect an ohmmeter between terminals A and H.
8. Adjust the switch to the point where there is continuity between the terminals.




9. Tighten the transaxle range switch mounting bolts.

Tightening torque: 7.9-10.7 N-m (70-95 in-lb)

10. Verify that the selector lever range position and transaxle range switch are aligned.
11. Connect the transaxle range switch connection
12. Connect the selector cable and install the nut and a new clip.
13. Install the battery carrier, air cleaner assembly, and battery.